Speed / RPM

Genuine Bosch hall effect speed sensor. Suitable for measuring crank, cam and wheel speed. Hall effect sensor so outputs a consistent amplitude square wave, no matter the speed. 4.5V to 24V supply voltage up to 4.2kHz frequency 0.5 to 1.4mm air gap...

  Anodised aluminium hall effect speed sensor 25.4mm (1") long with 15/32-32 thread. Needs to pick up from ferrous tooth or magnet. 5V to 24V supply voltage. air gap from tooth to sensor approximately 1.5mm Senses from near zero speed up 15KHz. Two...

Red anodised aluminium speed sensor 65.5mm long with M12x1.0 thread Pinout Brown: Supply VoltageBlue: Ground (0V)Black: Signal Output *requires pullup resistor on signal output, see datasheet for more information Downloads Datasheet  

Hall effect gear tooth sensor with Deutsch DTM connector Direct physical replacement for the discontinued Honeywell GT101 / 1GT101DC sensor. Features: senses ferrous metal targets digital current sinking output (open collector) better signal to noise...

Hall effect gear tooth sensor mainly for speed sensing. Direct physical replacement for the discontinued Honeywell GT101 / 1GT101DC sensor. Features: senses ferrous metal targets digital current sinking output (open collector) better signal to noise...